Engaging Four Wheel Drive-1450/1550 (option)
NOTE:
To avoid possible damage to the system, the combine is equipped with a device that disables four wheel drive when third speed is selected.
The two speed four wheel drive system is designed for use in extreme travel conditions or to improve steering control. When four wheel drive is engaged, the system becomes part of the closed circuit system of the hydrostatic drive.
For four wheel drive to function: the engine must be running, the four wheel drive solenoids must be supplied with electrical energy and the multifunction control handle must not be in neutral so that oil under hydrostatic pressure is supplied to the four wheel drive actuation system.
With four wheel drive engaged, the following reductions in forward speed will be observed, in comparison with two wheel drive at engine rated speed:
-
High speed, first transmission speed, approx. 15% reduction.
-
Low speed, first transmission speed, approx. 25% reduction.
-
High speed, second transmission speed, approx. 23% reduction.
-
Low speed, second transmission speed, approx. 35% reduction.
When four wheel drive is disengaged, an increase in ground speed will be noted.
NOTE:
To improve overall performance, it is recommended that the engine is run at low speed with maximum permitted torque. This will reduce general system pressure and oil temperature, prolonging the working life of the hydrostatic system and the four wheel drive motors.
|
|