Operational Adjustment of Harvest Performance Monitor (Continued)

1. If the needle moves towards "-" and stays there for more than 20 seconds, the combine's ground speed is too low, i.e. the harvester is not performing at its peak. In this situation increase combine ground speed until the needle returns to the center of the green sector.
2. If the needle moves towards "+" and stays there for more than 20 seconds, the combine's ground speed is too high and grain loss increases. Reduce combine ground speed until the needle returns to the center of the green sector.
3. If the needle remains in the "+" sector even after ground speed has been reduced, the straw walkers or sieve (cleaning shoe) may be plugged. In this case, check these components by selecting them individually with the selector switch. Remove the plug, if necessary. Once an acceptable level of performance has been achieved, adjust the potentiometers of the display unit as described above.
4. If harvesting conditions change during the course of the day (straw lying down or damp), or if the machine adjustment changes (fan speed), re-adjust the performance monitor. The sieve sensors may be moved fore-and-aft to any one of the three slots in the lateral supports.
5. Measure grain losses from time to time to determine whether the combine needs to be re-adjusted.

CQ213580

Sensor mounting, left

CQ213590

Sensor mounting, right

ML70882,00004BF -19-27JUL04-1/1