Support Axle Maintenance
This procedure is valid when the support axle is removed for checking (every 300 hours) or maintenance.
Removal procedure:
1.
Before removing any part, clean the steel track for any kind of service.
2.
Remove the steel track from the combine by following the reverse procedure for assembly.
3.
Remove bolt (1) to remove the cover (2).
4.
Pull the support shaft carefully (3).
5.
Check the retainers (4), seal (5), bushes (6) and axle (3). Remove all grease from the trunnion bearing (7).
Assembly procedure:
1.
With the bushes (6) in place, put the slightly greased retainers (4) in their seat on the trunnion bearing (7) and the covers (2).
2.
Grease the support axle surface (3) and then install a separator ring (8).
3.
Insert the shaft (3) on the trunnion bearing (7).
IMPORTANT:
Take care not to damage the retainers (4).
4.
With the support axle in position, install the other separator ring. On the slash on the end of the support axle, place the sealing ring (5).
5.
Put the cover (2) back. Put lithium-based grease back on the trunnion bearing (7) through the cover orifice. To help with greasing, turn the axle a few times. Only stop adding grease when it starts to come out from the hole on the cover (2).
6.
Fix the bolt (1). Turn the support axle five times for the grease to spread well.
7.
Reinstall steel track on combine.
|
|