Service points-Every 10 hours

CQ219650

OU83340,00003E9 -19-11SEP03-1/2


IMPORTANT: Service times are for average conditions. Service more often if combine is used in extreme conditions.

1. Check engine oil level by means of dipstick.

NOTE: Only check the oil after the engine has been shut off for at least 30 minutes.

2. Check the hydraulic system oil level. Check with the header lowered to the ground. The oil level should be more or less in the center of the scale. Add oil recommended by John Deere, if necessary.

3. Check the hydrostatic drive oil level. Check with the header lowered to the ground. The oil level should be more or less in the center of the scale. Add oil of the same brand, if necessary.

4. Check the air compressor oil level by means of the oil level plug. Add oil, if necessary.

NOTE: During the first 50 hours of operation the air compressor has a very high oil consumption, because of this it is very important to check the oil level daily and refill it, if necessary. After the first oil change consumption is greatly reduced.

IMPORTANT: In the event that the air compressor continues to consume a very large quantity of oil after 50 hours have expired, check for leaks in the connections and lines.

5. Check the condition and coolant level in the cooling system. Add water and additives according to the proportions specified in the "Fuel, Lubricants, Coolant and Capacities" section.

IMPORTANT: Only refill the cooling system with the engine shut off and at ambient temperature.

6. Check the condition and cleanliness of the rotary radiator screen. Clean it, if necessary. Check also the condition of the engine and air conditioning (if installed) air filters.

7. Lubrication points: two points. One in front of the beater pulley and the other point in front of the variable speed drive pulley of the threshing cylinder without reduction gears.

IMPORTANT: These points must be lubricated with the pulleys closed. USE grease to lubricate the variable speed drive of the cylinder without reduction gears.

8. Check the condition of the fuel system.

9. Lubrication point: two points (on both sides), on the rear wheel steering system.

10. Torque: Retighten retaining screws between hydraulic steering cylinder and rear axle to 24 kgf.m (240 N.m; 174 lb-ft).

11. Check condition and inflation of tires. See table under "Tire Inflation Pressure" in the "Wheels, Axles and Counterweights"section.

Carry out the first retightening of all rear wheel bolts with a torque of 18 kgf.m (180 Nm; 130 lb-ft). Thereafter, repeat this procedure every 200 hours.

12. Lubrication point: two points on rear-wheel drive linkages.

13. Lubrication point: one point on rear axle pivot fitting.

14. Lubrication point: two points (one on each side of machine) on straw chopper bearings.

OU83340,00003E9 -19-11SEP03-2/2