Service points-Every 10 hours

CQ219700

OU83340,00003EA -19-12SEP03-1/2


IMPORTANT: Service times are for average conditions. Service more often if combine is used in extreme conditions.

1. Lubrication point: two points - one on engine fan bearing and the other on the air compressor and air-conditioning drive shaft bearing.

2. Lubrication point: three points. One on each idler pulley of the straw chopper belt and one point on the idler arm.

3. Lubrication point: one point on the straw chopper drive pulley bearing.

4. Lubrication point: two points on rear-wheel drive linkages.

5. Lubrication point: one point on rear axle linkage.

6. Check condition and inflation of tires. See table under "Tire Inflation Pressure" in the "Wheels, Axles and Counterweights"section.

Carry out the first retightening of all front wheel bolts with a torque of 55 kgf.m (550 Nm; 400 lb-ft). Thereafter, repeat this procedure every 200 hours.

7. Check shift lock solenoid operating function (CWS/WTS).

8. Carry out the first retightening of final drive retaining screws to 35 kgf.m (350 N.m; 252 lb-ft). Thereafter, repeat this procedure every 50 hours.

NOTE: Check the recommended torque under "Metric Bolt Tightening Values".

9. Check cleanliness and function of all machine lights.

NOTE: After roughly cleaning the lamp lenses, wipe with a cloth moistened in household alcohol for better lamp performance.

OU83340,00003EA -19-12SEP03-2/2