|
IMPORTANT:
Service times are for average conditions. Service more often if combine is used in extreme conditions.
1.
Lubrication point: one point on drive arm of the right-hand cleaning shoe.
2.
Lubrication point: three points on the bearings of the drive belt idlers located next to the engine power takeoff.
3.
Change the air compressor oil for the first time, bleeding off the spent oil through the drain plug (A).
NOTE:
Thereafter, change the oil every 200 hours.
4.
Lubrication point: one point on the feeder house drive pulley bearing.
|
NOTE:
The 300 (A) and 600 (B) series feeder house bearings are identical. However, on the 600 series the plastic shield must be removed in order to access the bearing.
5.
Lubrication point: two points - one on the drive pulley of the tailings elevator, fan and straw walker and the other one on the fan bearing.
6.
Carry out the first oil change of the transmission box, removing the spent oil by means of the drain plug (A).
IMPORTANT:
Thereafter, change the transmission oil every 500 hours.
7.
Lubrication point: one point on each wheel hub.
8.
Lubrication point: one point on the hitch.
|