|
IMPORTANT:
Service times are for average conditions. Service more often if combine is used in extreme conditions.
1.
Lubrication point: one point on the linkage of the transmission drive sheave of the straw chopper.
2.
Lubrication point: two points. One point on each bearing of the transmission drive sheave of the straw chopper.
3.
Lubrication point: one point on rear axle linkage.
4.
Lubrication point: two points - one point on the fan bearings and the other on the drive arm of the left-hand side cleaning shoe.
|
5.
Lubrication point: two points. One on the upper part (A) and one on the lower part (B), on the bearings of the swing cylinder of the unloading auger.
6.
Lubrication point: one on the header drive pulley.
7.
Lubrication point: one on the feeder house drive pulley.
8.
Lubrication point: one on the bearings of the drive belt idler of the hydrostatic pump.
9.
Lubrication point: four points on the unloading auger. Two points on the shaft and two on the auger linkage. To access these points the grain tank must be empty, and the end of the shield raised.
|