|
IMPORTANT:
Service times are for average conditions. Service more often if combine is used in extreme conditions.
1.
Change filter (A) and the engine oil for the first time. Before changing the oil set the engine running for around 5 minutes in order to heat up the oil.
Further oil and filter changes must be carried out every 500 hours.
IMPORTANT:
Ensure that your hands and the engine are perfectly clean when installing replacement filter elements or changing the oil.
NOTE:
Engine oil is bled off via the drain plug (B - see description in "100 hour service points- front left-hand side"). On the 1550 combine the engine oil is drained off via the drain plug (C - see description in "100 hour service points- front left-hand side").
2.
Replace hydraulic system oil filter.
|
3.
Fuel system: inspect the entire system after the first 100 hours.
4.
Check connections on fuel injection lines
5.
Replace drier filter if the system becomes contaminated with air or every 100 hours.
6.
Change the oil of final drives for the first time.
Further oil changes must be carried out every 1000 hours.
NOTE:
Clean vent plug of the final drive.
7.
Check play of final drive flanged axle bearings only on steel tracked rice combines. Adjust, if necessary. Further checks must be carried out every 500 hours.
8.
Check the tightness of hose clamps and connections.
|