|
IMPORTANT:
Service times are for average conditions. Service more often if combine is used in extreme conditions.
1.
Clean cab air filters with hand brush furnished with the machine.
CAUTION:
When cleaning or changing air filter, shut off engine and remove starter key.
IMPORTANT:
Clean these elements whenever air flow is noticeably reduced. The recirculating filter may not require as frequent cleaning as the fresh air (main) filter.
|
2.
Replace hydrostatic system filter.
Change the oil of the hydrostatic system (only if John Deere
Hy-Gard
®
is not used) by means of drain plug (E).
3.
Check and, if necessary, retighten front axle retaining bolts. Thereafter, repeat this procedure every 500 hours.
NOTE:
Check the recommended torque under "Metric Bolt Tightening Values".
|