|
IMPORTANT:
Service times are for average conditions. Service more often if combine is used in extreme conditions.
1.
Retighten rear wheel nuts to 18 kgf.m (180 N·m; 130 lb-ft).
NOTE:
Four wheel drive: retighten wheel nuts to 20 kgf.m (200 N·m; 145 lb-ft).
2.
Change the air compressor oil by bleeding off the spent oil through the drain plug (A).
3.
Check the level of brake fluid. Pull back cover to gain access.
|
4.
Retighten front wheel nuts to 55 kgf.m (550 N·m; 400 lb-ft).
5.
Lubrication point: one point on the unloading auger drive gear.
6.
Check the oil level in the transmission box through oil level check plug (B).
7.
Lubrication point: two points. One point on the pulley and the other on the bearing of the separator fan.
|