Four Wheel Drive Axle Height and Width Adjustment-1450/1550 (option)

Rear axle has width and height adjustment. Rear wheels must be aligned in relation to front wheels. Adjust machine leveling in relation to soil by altering the height as required.

On 1450, CWS and WTS combines width may be adjusted to 3 positions (A, B and C).

On 1550 CWS/WTS combines width may be adjusted to 2 positions (B and C).

Height may be adjusted to 2 positions (H1 and H2).

CQ219070

Width control setting

CQ219080

Height control setting

OU83340,00003F7 -19-30JUL04-1/2


Width control setting:

1. Shut off machine to relieve hydraulic system pressure.
2. On flat ground, raise rear axle so as to free both wheels.

causym CAUTION: Use equipment that is compatible with the combine weight. If a hydraulic jack is used, position it correctly under the shaft at the defined jacking points.


3. Loosen the two nuts (A) on both sides and remove bearing bolts of hydraulic cylinder (B).
4. Loosen the two bolts (C) of tie rod (D).
5. Loosen nuts (E) on both sides of the four wheel drive axle (F).
6. Displace wheel hub to one of the positions.
7. Retighten all bolts and put wheels back in place.

IMPORTANT: Adjust toe-in of rear wheels See "Rear Wheel Toe-In"


NOTE: Bearing of hydraulic cylinder (B) has to be displaced according to axle positions (A, B or C).

NOTE: Bolts of nuts (E) never change position.

Height control setting:

1. Repeat procedure for width adjustment, skipping step 4.

NOTE: The check of rear wheel toe-in is not necessary.


CQ219091
CQ219101
CQ219111

OU83340,00003F7 -19-30JUL04-2/2