Engine Coolant

causym CAUTION: Hazard to health if swallowed. Risk of death! Basic ingredient: Ethylene Glycol. If swallowed, call a doctor immediately. Avoid breathing in the mist or fumes! Do not store in open recipients or a recipient without a locking device. Wash yourself thoroughly after handling the product. Excessive contact may cause abnormalities in unborn children. Keep out of reach of children and animals.

- John Deere antifreeze concentrate is a high performance cooling antifreeze principally composed of ethylene glycol with special organic additives.

- Developed to fulfill the requirements of current heavy duty engines.

- Provides protection against corrosion of the water pump.

- Stops cavitation and avoids freezing in winter and overheating in summer.

Characteristics:

·The use of John Deere Conditioner will be necessary if the engine has been used for a long time.

·Evaluate the amount of SCA (Supplemental Coolant Additives) annually or add SCA following the instructions given in the operator's manual, if this is the first time.

·The same product that engines are filled up with on assembly line.

·Phosphate-free composition.

Biodegradable

Applications:

Recommended for all John Deere diesel engines.

CQ190750

TY16034 Engine Cooling Antifreeze Concentrate

REFRIMOTOR -19-15AUG02-1/2


Use guidelines:

causym CAUTION: Never remove the radiator cover with the engine hot. Remove the starter key from the ignition to prevent accidental engine start.

1. Verify the cooling system to make sure that all connections are tight and all components are in a satisfactory condition.
2. Inspect the thermostatic valves to make sure that they open at the correct temperatures.
3. Completely bleed the cooling system and refill it with water. With the radiator cover open, start the engine and run for about 10 minutes.
4. Shut off engine. Bleed the system again. If the system is still dirty, clean the radiator with a good quality cleaner to remove the rust, scales and sediments.
5. Previously mix in a recipient TY 16034 coolant concentrate with water of low mineral text, in the ratio of 1 part of coolant to 1 part of water. Add the solution until 25 mm above of the level in the radiator. TY 16036 coolant liquid is supplied already diluted, so it can be directly added to the radiator.
6. Start the engine again with the radiator cover open in order to mix the coolant and expel the air. Shut off the engine and let it cool down.
7. Check the cooling liquid level again. Add more solution, if necessary.

REFRIMOTOR -19-15AUG02-2/2