Soybeans / Sunflowers (Oil) and (Confection) / Wheat

NOTE: The following settings for various crops are for average conditions. Varying crop and field conditions may require slightly different settings.

Soybeans 1

Sunflowers (Oil)

Feeder House Drum Position

Down

Feeder House Drum Position

Down

Feeder House Conveyor Chain

26 Tooth

Feeder House Conveyor Chain

26 Tooth

Feed Accelerator Speed

High 2

Feed Accelerator Speed 2

Low

Feed Accelerator Wear Strips

Serrated

Feed Accelerator Wear Strips

Serrated

Threshing Speed (rpm)

450—650

Threshing Speed (rpm)

300—400 3

Concave Clearance

15—25

Concave Clearance

30—40

Concave Type

Round Bar/Large Wire

Concave Type

Round Bar/Large Wire

Separator Grate Covers

None

Separator Grate Covers

Use as required 4

Fan Speed (rpm)

800—950

Fan Speed (rpm)

650—850

Chaffer Settings

14—18 mm (9/16—11/16 in.) 5

Chaffer Settings

13—15 mm (1/2—19/32 in.)

Sieve Settings

6—9 mm (1/4—11/32 in.) 6

Sieve Settings

7—9 mm (9/32—3/8 in.)

Sunflowers (Confection)

Wheat

Feeder House Drum Position

Down

Feeder House Drum Position

Down

Feeder House Conveyor Chain

26 Tooth

Feeder House Conveyor Chain

26 Tooth 7

Feed Accelerator Speed 2

Low

Feed Accelerator Speed 2

High

Feed Accelerator Wear Strips

Serrated

Feed Accelerator Wear Strips

Serrated

Threshing Speed (rpm)

300—400 3

Threshing Speed (rpm)

750—950

Concave Clearance

30—40

Concave Clearance

5—20

Concave Type

Round Bar/Large Wire

Concave Type

Small Wire

Separator Grate Covers

Use as required 4

Separator Grate Covers

Use as required 4

Fan Speed (rpm)

650—850

Fan Speed (rpm)

750—850

Chaffer Settings

13—15 mm (1/2—19/32 in.)

Chaffer Settings

16—18 mm (5/8—11/16 in.)

Sieve Settings

7—9 mm (9/32—3/8 in.)

Sieve Settings

5—7 mm (3/16—9/32 in.)

1 If harvesting corn and soybeans, it is not necessary to remove separator grate spacers. Remove spacers for all other crops.
2 For improved straw quality in dry crops and grain quality, use low speed.
3 Do not operate below minimum speed recommendation.
4 In shoe overloading conditions in dry crops, with small wire concaves, initially install two rows on right side and three rows on left side. Large wire concaves, initially install three rows on right side and two rows on left side. Adjust number and pattern as required by condition.
5 Deep tooth chaffer 10—12 mm (3/8—1/2 in.)
6 Deep tooth sieve 4—6 mm (5/32—1/4 in.)
7 32 tooth is recommended for high yielding, high volume poor feeding straw crops. Requires high feeding package or conversion from service parts.

OUO6075,0000188-19-20080702