Cleaning Machine

Cleaning outside of machine

• Wash outside of machine using a power washer.
• Use a soft absorbent cloth to wipe off water droplets.
• Use a good clear wax or glazing compound that contains no abrasives and lint free towel.
• Apply wax or compound on a cloth and rub into panel in a circular motion. After compound is rubbed into panels, turn towel over and buff out with the other (dry) side.

Cleaning plastic parts:

NOTE: Do not clean plastic parts with fuel or other petroleum based cleaners.

Always follow manufacturers directions when using cleaner and test on a small hidden area first.

• Some machine trim parts are plastic. Use tar and road oil remover to remove dirt, wax buildup and other deposits.

Vinyl and plastic parts:

• Remove dust and dirt with a whisk broom or vacuum cleaner. Clean vinyl surfaces with leather and vinyl cleaner.
• Clean surfaces with clean, soft damp cloth.
• For more thorough cleaning, wipe surface with soft cloth and mild detergent.
• Remove excess detergent with clean dry cloth.

Cleaning Fabric:

NOTE: Always follow manufacturers directions when using fabric cleaner and test on a small hidden area first.

• Remove dust and loose dirt with whisk broom or vacuum cleaner.
• Remove excess staining material by scraping or wiping with clean cloth.
• For water soluble stains, use a damp cloth first, followed by a soft cloth with a mild detergent and water.
• For grease, oil, tar or other petroleum based stains, apply fabric cleaner to soiled area following the manufactures directions.