| Symptom | Problem | Solution |
|
Uneven or bunched feeding of crop to rotor.
| Header auger too high. |
Adjust auger down and
back. See header operator's manual.
|
| |
Buildup of grain on cutterbar.
|
Lower reel and set fore-and
aft position as close as possible to cutterbar and auger. See platform
operator's manual.
|
| |
Front of feeder conveyor chain adjusted too high.
|
Adjust feeder drum so
conveyor slat clears bottom with correct clearance.
|
| |
Feeder conveyor chain too tight and holds drum up.
|
Adjust conveyor chain
to correct tension.
|
| |
Header drive belt slipping.
|
Spring-loaded idler must
be free and tight against belt.
|
| |
Auger too far ahead of stripper.
|
Adjust auger back to stripper.
See header operator's manual.
|
| |
Feeder conveyor drive chain not on correct sprocket.
|
Place chain on correct
sprocket.
|
| |
Feeder conveyor slats bowed up.
|
Straighten or replace
bent slats.
|
| |
Dirt and sap buildup on feeder house bottom.
|
Clean bottom.
|
| |
Too great a distance between platform auger and feeder
house front drum.
|
Add links to feeder house
chain.
|