| Step |
Action |
Go to: |
| Prepare Header for Calibration |
Hook up header to combine and ensure header harness is connected to main combine harness. Check that header height sensors are in working condition.
Make sure machine is on a level surface. |
GO TO Step 1 |
| 1 - Select Diagnostic Mode |
INFO-TRAK™ monitor is used for diagnostic mode. While pressing the up/down button on INFO-TRAK monitor, turn combine key switch on and start engine.
Display should indicate:
- -
dlA |
OK: GO TO Step 2
NOT OK: Check INFO-TRAK Monitor |
| 2 - Select HCU (Header Control Unit) |
Press the "fan" key on Infotrak until "HCU" is displayed.
Display should indicate:
0000
HCU |
OK: GO TO Step 3
NOT OK: See your nearest dealership |
| 3 - Enter header calibration mode |
Press the up/down key on INFO-TRAK monitor until obtaining address 30.
Display should indicate:
0030
HCU
Press fan speed key on INFO-TRAK monitor to access header calibration mode 30
Display should indicate:
0030
Hdr |
OK: GO TO Step 4
NOT OK: Check INFO-TRAK Monitor |
| 4 - Calibrate height system and return-to-cut. Define sensor minimum settings |
Lower header until it rests fully on ground by "raise/lower" switch on multi-function lever handle.
Left- and right-hand sides of header should contact ground at the same time as the header is lowered. Press "Fan Speed" button on INFO-TRAK monitor.
Display should indicate:
0030
H - d
Press return to cut knob on multi-function control handle.
Display should indicate:
0030
H - U |
OK: GO TO Step 5
NOT OK: Header does not rise or lower, check hydraulic system.
NOT OK: Display does not change to "H-U", make sure "raise/lower" switch is off. See your nearest dealership
NOT OK: Display "E5X", "E7X", "E8X" or "E9X" indicates an error. See your nearest dealership
NOT OK: Display does not change from "r-d". See your nearest dealership |
| Step |
Action |
Go to: |
| 5 - Establish maximum sensor settings. |
Use raise/lower switch on multi-function control handle to raise header fully. Press return to cut knob on multi-function control handle.
Display should indicate:
0030
EOC |
OK: GO TO Step 6
NOT OK: Display "E5X", "E7X", "E8X" or "E9X" indicates an error.
See your nearest dealership |
| 6 - Store header calibration data. |
Press "Fan Speed" knob on INFO-TRAK monitor to store all calibration values. If no errors occurred during calibration, the following will be displayed:
EOC
E00
END
If any errors occurred during calibration, previous calibration values are kept and display reads:
EOC
Err
END |
OK: Calibration is done. GO TO Step 7
NOT OK: See your nearest dealership |
7 -
Reset to normal operation. |
Turn starter key to position "0" to return automatic control system to normal operation at next machine start-up. |
|