Replace Engine Safety Filter

1. 
   CQ298927-UN-24MAR15

   
   CQ298928-UN-24MAR15

   A - Snap Latches (6 used)

   B - Dust Cover

   C - Primary Filter

   D - Safety Filter

   Set park brake, shut OFF engine and remove key so dirt cannot be pulled into engine.

---




2. Inspect and clean filter housing before removing filters.

3. Open the snap latches (A) and remove dust cover (B).

4. Carefully remove the primary filter (C), by slightly moving it from side to side while pulling outward.

5. Completely clean the inside of the housing using a damp cloth. Do not remove safety filter (D) until housing is clean.

6. IMPORTANT:

   • Only remove the safety filter to change it, i.e. not remove and reinstall the same filter without.
   • The safety filter admits no cleaning.
   
   

   Unscrew safety filter (D) in a counterclockwise direction to remove.

7. Clean gasket sealing surface on new filter before installation. Filters must be fully seated to avoid contamination of the intake system.

   NOTE: Use only John Deere recommended engine air filters.

8. Install a new safety filter and primary filter.

9. Install previously removed dust cover and snap latches.