Use a Booster Battery / Battery Charger

CAUTION:

TS204-UN-15APR13

T8120000495-UN-20FEB12

A - Booster Battery/Battery Charger

B - Weak Battery

C - POSITIVE (+) Connections

D - NEGATIVE (-) Connections

A compatible 12V battery or battery charger (A) can be connected in parallel with existing battery (B) on machine to assist in weak battery or cold weather starting.

ALWAYS use heavy duty jumper cables.

CAUTION: Gases given off by battery can explode. Keep sparks and flame away from batteries.

Before making/removing connections to a battery charger, turn charger OFF.

ALWAYS connect NEGATIVE (-) cable last, and connect away from battery. ALWAYS disconnect NEGATIVE (-) cable first, and disconnect from weak battery first.

IMPORTANT: Verify polarity is correct before making jumper connections. Reversing polarity will cause damage to electrical system.

ALWAYS connect positive to positive and negative to ground.

Only use a compatible booster battery that has same voltage rating. (12V — 12V)

1. Connect one end of jumper cable to POSITIVE (+) post of booster battery.

2. Connect other end of same cable to POSITIVE (+) post of existing battery. (C)

3. Connect one end of jumper cable to NEGATIVE (-) post of booster battery.

4. Connect other end of same cable to good ground connection on frame (D), away from existing battery.

5. Start engine and disconnect cables immediately after engine is running. Disconnect ground connection on frame first.