Calibration Procedures—When to Calibrate

This list shows all possible calibrations. Depending on machine options listing shown may not match calibration menu shown on display.

IMPORTANT: Error codes shown on display if a problem exists during a calibration procedure. Conditions causing error must be corrected before continuing calibration.

• “Basecutter Height”—Perform calibration when base cutter height sensor components are replaced, serviced, or adjusted.

• “Primary Extractor OL”—Perform calibration when primary extractor fan components are replaced, serviced, or adjusted.

• “Hydro Handle Position Cal”—Perform calibration when hydro handle position sensor is replaced, serviced, or adjusted.

• “Steering Wheel Position Cal”—Perform calibration when steering wheel input device (SID) is replaced, serviced, or adjusted.

• “Left Crop Divider Position”—Perform calibration when left crop divider position sensor components are replaced, serviced, or adjusted.

• “Right Crop Divider Position”—Perform calibration when right crop divider position sensor components are replaced, serviced, or adjusted.

• “Left Crop Divider Pressure”—Perform calibration when left crop divider pressure sensor components are replaced, serviced, or adjusted.

• “Right Crop Divider Pressure”—Perform calibration when right crop divider pressure sensor components are replaced, serviced, or adjusted.

• “Basecutter Target Height”—Perform calibration when base cutter height sensor and crop divider position sensor components are replaced, serviced, or adjusted.

• “Hydro Displacement Field Cal”—Perform calibration when pump EDC valve is replaced, serviced, or adjusted.

• “Varitorque Cal”—Perform calibration when varitorque potentiometer is replaced, serviced, or adjusted.