Monitor Crop Divider Position

T8T1902
T8T1902-UN-23JAN15

A - Left-Hand Crop Divider Position

B - Right-Hand Crop Divider Position

If floating crop divider and contour base cutter height control system is acting erratically, monitor the crop divider positions.

  1. Set detail machine information region to display left-hand and right-hand crop divider positions (A and B).

  2. Run machine with floating crop divider and contour base cutter height control systems engaged.

  3. If crop divider positions go down to zero, the crop dividers are all the way lowered and not touching the ground. Change the pin position of the crop dividers and recalibrate the crop divider positions and pressures. See Adjust Crop Divider Height in Operating the Harvester section and Calibrate System in this section.

WM05597,000116A-19-20150128