ComfortCommand™ Operator's Seat (Premium Cloth Seat)—Adjusting

NOTE:

H96739
H96739-UN-02JUN11

ComfortCommand™ Operator's Seat

Seat is equipped with an operator presence system. If operator leaves seat after header and separator engagement, the header and separator will disengage. Separator rotational alarm sounds and outside lights flash to alert operator of leaving seat with the separator still rotating. Alarm sounds and lights flash until the separator has come to a complete stop.

A—Fore/Aft Adjustment Handle - slides seat forward or rearward for the best working position.

B—Vertical Shock Dampener Control - limits amount of “upward motion” the seat suspension provides.

NOTE: Push control forward for a soft ride or move control back for a firm ride. Medium firmness is between these two positions.

C—Weight/Height Adjustment Handle - raises or lowers the seat. Pull up on handle to raise seat or push down on handle to lower seat. Adjust seat until green marking is visible in the weight/height indicator.

NOTE: Suspension can be adjusted to reach limits in minimum and maximum heights, which locks out the suspension system making it rigid. Suspension height control also hits limits if adjusted too close to the extremes.

Do not operate the compressor for more than one minute when adjusting seat.

If seat does not float or “pump” up, see your John Deere dealer or qualified service provider.

D—Weight/Height Indicator - provides a visual indicator to operator on the current weight and height setting. Use weight/height adjustment handle to adjust seat until green marking is visible in indicator.

NOTE: Adjust seat to operator weight and height. This allows the operator to get the most ride zone protection. Seat has a built-in buffer at the high and low end of vertical seat travel, resulting in a much smoother ride.

E—Seat Bottom Depth Adjustment Handle - moves seat bottom forward or rearward for the best working position.

F—Seat Bottom Angle Adjustment Handle - raises or lowers seat cushion for the best working position.

G—Fore/Aft Isolation Adjustment Handle - locks out or releases forward or rearward movements. Pull up on handle to lock or push down on handle to release.

NOTE: Fore/Aft isolator allows shock impacts to be absorbed.

H—Side Isolation Adjustment Handle - locks out or releases side-to-side movements. Push handle forward to release and pull handle rearward to lock.

NOTE: Side isolation allows shock impacts to be absorbed.

ComfortCommand is a trademark of Deere & Company

OUO6075,000412B-19-20160504