Attaching Hay Tedder To Tractor-756

CAUTION: To avoid bodily injury or machine damage whenever an implement is attached, put transmission in PARK position and check the full range of hitch for interference, binding, or PTO separation.

2. Connect push pin driveline (C) to tractor PTO shaft. Fold down PTO support. Attach PTO safety shield chain (D) to drawbar to hold shield in place.

3. Connect hydraulic hose (E) to tractor SCV.

4. Attach pull cord (F) to tractor.

5. Attach safety chain (G). Remove all slack except what is needed for turns.

6. Lower jackstand and remove from support (H) and store in storage area (J). Lower PTO support stand (I) while hay tedder is in use.

7. Pull pin (K) and lift rear stand (L) to stored position.

A-Hitch Pin
B-Clip
C-PTO Shaft
D-PTO Safety Chain
E-Hydraulic Hose
F-Pull Latch
G-Safety Chain
H-Jackstand Bracket
I-PTO Stand
J-Jackstand Storage Position
K-Pin
L-Rear Stand

EX,945IW,A1 -19-21MAY99-1/1