Install Optional Reduction Gear Case

1. Install support bracket (A) onto reduction gear case with two M8 x 80 cap screws (B).

2. Remove plastic cover from main gear case.

3. Install one of the two snap rings onto drive shaft (C).

4. Remove two M12 x 30 cap screws from right-hand side of main gear case.

5. Slide reduction gear case onto drive shaft (C). Fasten to main housing with two M12 x 35 cap screws (D) and washer.

6. Install second snap ring onto drive shaft (C).


A-Bracket
B-Cap Screws, M8 x 80
C-Drive Shaft
D-Cap Screws, M12 x 35

E36793

OUO6059,00004BE -19-03JUN02-1/1