Adjusting Starter Roll Scraper (If Equipped)

causym CAUTION: Be careful when working around starter roll scraper. The knife is sharp and can cause serious injury.

Rotate starter roll in direction shown to avoid pinching fingers.

1. Clear area of all debris between knife and starter roll.

TS268

AG,OUO6077,1031 -19-08AUG00-1/2

2. Loosen cap screws (A).

3. Set scraper bar (B) to specifications to clear starter roll bars.

Specification

Scraper Bar-to-Starter Roll Bars -Clearance (Minimum) 0.5-1.0 mm (0.020-0.040 in.)

4. Tighten cap screws (A).

5. Manually rotate starter roll (D) to check clearance at all bars. Readjust as necessary.

E51108


A-Cap Screws
B-Scraper Bar
C-Clearance
D-Starter Roll

AG,OUO6077,1031 -19-08AUG00-2/2