BALETRAK PLUS® Monitor-Controller Diagnostic and Setup Channels

NOTE: Channel listings and page numbers can be found under Operating the Baler or Service-

Baler in the Contents or under section "C" in the Index.

CHANNEL NUMBER FUNCTION
1 Return to Initial Settings
3 Adjust Twine Wrap Sensor With Sound
5 Adjust Bale Diameter Sensor With Sound
7 Adjust Right Bale Shape Bar Display and Sensor With Sound
9 Adjust Left Bale Shape Bar Display and Sensor With Sound
10 Test Net Wrap Switch
11 Test Oversize Bale Switch
12 Test Right-Hand Gate Latch Switch
13 Test Left-Hand Gate Latch Switch
14 Test Twine or Net Actuator Current
15 Check Tractor Voltage
16 Test Liquid Crystal Display
17 Dry Straw Twine Wrap Program
18 Adjust Re-Extension Wrap Distance and Cinch Wrap
19 NOT USED
20 NOT USED
21 NOT USED
22 NOT USED
23 NOT USED
24 Adjust Bale Shape Sensitivity
25 Adjust Near-Full Indicator
26 Net Wrap Delay
27 NOT USED
The following channels have been programmed to perform adjustments WITHOUT the audible alarm.
CHANNEL NUMBER FUNCTION
2 Adjust Twine Wrap Sensor
4 Adjust Bale Diameter Sensor
6 Adjust Right Bale Shape Bar Display and Sensor
8 Adjust Left Bale Shape Bar Display and Sensor

 

BALETRAK PLUS is a registered trademark of Deere & Company

AG,OUO6059,218 -19-10JUL00-1/1