Fire ExtinguisherA 9.5 L (2-1/2 gal) pressurized-water fire extinguisher can be mounted in the holes that are provided on the baler. (See your John Deere dealer.) Equip the baler with a water-type fire extinguisher. Extinguisher should be properly charged and easily accessible in an emergency. Large capacity water fire extinguishers are recommended because application of water can cool hot parts to prevent a fire. If a fire does occur, water will help drown the flame and cool off hot parts, to prevent the fire from rekindling. Train operators on proper use of the extinguisher and the need to keep it charged at all times. if baler is subject to cold weather, use an approved nonflammable anti-freeze solution to prevent damage. |
AG,OUMX005,1331 -19-18MAR00-1/5 |
|
Install Fire Extinguisher-457 and 557
NOTE: If bracket holes do not align with holes in baler, drill new holes in the bracket, NOT the baler. 1. Install bracket on left-hand front panel. Fasten with four M8 x 25 cap screws (A), 9 x 28 x 3 mm washers, and nuts.
|
|
AG,OUMX005,1331 -19-18MAR00-2/5 |
|
2.
Fill, pressurize and test fire extinguisher. If baler is subjected to cold weather, a nonflammable antifreeze solution should be used to prevent damage to extinguisher.
3. Fasten fire extinguisher to bracket. |
|
AG,OUMX005,1331 -19-18MAR00-3/5 |
|
Install Fire Extinguisher-457 Silage Special
NOTE: If bracket holes do not align with holes in baler, drill new holes in the bracket, NOT the baler. 1. Install two M10 x 35 cap screws (A) through front of baler. Install flange nut on each cap screw (nuts are used as spacers.) Tighten nuts. 2. Install bracket (B) on baler. Install flange nuts on cap screws (A). 3. Install flange nuts (C). |
|
AG,OUMX005,1331 -19-18MAR00-4/5 |
|
4.
Fill, pressurize, and test fire extinguisher. If baler is subjected to cold weather, a nonflammable antifreeze solution should be used to prevent damage to extinguisher.
5. Fasten fire extinguisher to bracket. |
|
AG,OUMX005,1331 -19-18MAR00-5/5 |