Adjusting Initial Length of Hydraulic Lift Cylinder (If Equipped)

E39758
 

A-Distance

  

IMPORTANT: If the hydraulic pickup lift cylinder has been removed, the initial length of cylinder must be adjusted before installing the cylinder.

1. Extend cylinder fully.

2. Install cylinder stop, jam nut, washer (MegaWide pickup only) and end block onto cylinder rod.

3. Turn cylinder rod into end block until distance (A), from center of hole in base end of cylinder-to-center

hole in end block, is within specifications.

Specification

Center of Hole in Base End of Cylinder-to-Center Hole in End Block -Distance (Initial Length) 606 mm (23-7/8 in.)

4. Install cylinder on baler.

AG,OUMX005,1538 -19-03AUG00-1/1