Testing Tractor Convenience Outlet Voltage (Channel 019)

Complete the following check to determine if the convenience outlet provides adequate power to the Bale Trak ™ Pro system.

2. Press and hold COUNTER key (A) while turning monitor-controller ON.

3. Continue to hold COUNTER key and press PLUS key until "CH 019" appears in the digital display.

4. Release COUNTER key and view voltage readout.

5. Using EXTEND key, extend twine actuator slightly.

6. Push and hold RETRACT key until actuator stalls out in the cutoff position and note voltage displayed during the first 4 seconds after stalling.

Specification

7. If voltage is less than specifications, install Convenience Outlet Kit AE50549. Only this kit should be used to provide a convenience outlet due to its wire size, lack of splices and circuit breaker included in this kit. When installing this kit, attach power and ground wires directly to battery terminal clamp bolts, only. (See TRACTOR CONVENIENCE OUTLET in Preparing the Tractor section.)

8. Turn monitor-controller OFF. Turn off tractor engine and remove key.

A-COUNTER Key

BALE-TRAK is a trademark of Deere & Company

AG,OUMX005,1547 -19-24JUN03-1/1