BaleTrak™ Pro Monitor-Controller Diagnostic and Setup Modes

There are two types of channelled programs:

  • Diagnostic
  • Setup

Setup Channels are used to:

  • Adjust bale shape bar display.
  • Set near-full indicator set point.
  • Reset monitor-controller to initial settings.
  • Adjust net wrap delay.
  • Set bale shape display sensitivity.
  • Access dry straw twine wrap program.
  • Adjust bale diameter
  • Adjust twine wrap
  • Activate Re-extension and Cinch wrap program

NOTE: Diagnostic procedures are located in the Service-Baler section.

Diagnostic Channels are used to:

  • Check positions of sensors and switches.
  • Test twine or net actuators.
  • Test LCD display.
  • Test tractor voltage.

To enter Diagnostic and Setup Channels:

1. Turn tractor key to ON position. Do not start tractor engine. Press and hold COUNTER key (A), while turning monitor-controller ON.

2. Continue to hold COUNTER key (A) and press PLUS key until desired channel appears in digital display. Release key to see the current value for this channel.

To change channels, press and hold COUNTER key (A) and use the PLUS and MINUS keys to access other channels.

E52441


A-COUNTER Key

AG,OUO6059,217 -19-10JUL00-1/1