Install Gauge Wheel Arm Assembly (MegaWide Pickup)

Guage Wheel Assembly

1. Assemble wheel and gauge arm in the following manner:

    IMPORTANT: Small washer (C) must go onto bolt (B) first or wheel will not rotate after assembly.

  • Place wheel with cap screw heads facing up.
  • Place small washer (C) on bolt (B).
  • Insert bolt (B) through wheel (H) so threads are facing same direction as wheel cap screw heads (A).
  • Place spacer (D) on bolt.
  • Place one (1) large washer (E) on bolt.
  • Place slot in gauge arm (F) on bolt.
  • Place one (1) large washer (E) and nut (H) on bolt.

2. Tighten nut and bolt, ensure wheel will rotate freely.

3. Repeat Steps 1and 2 for opposite side.

Install Gauge Wheel Arm Assembly (MegaWide Pickup)


A-Cap Screw
B-Bolt
C-Small Washer
D-Spacer
E-Large Washer
F-Gauge Arm
G-Nut
H-Gauge Wheel

E52057
E52058

AG,OUO6059,284 -19-26JUN03-1/2

1. Remove gauge wheel arm assemblies (A) from shipping pallet.

2. Remove two 3/8-in. nuts and end cap (D).

3. Install two straps (B) and gauge wheel arm assembly (A) with two M12 x 16 cap screws (C).

4. Install end cap (D) with two 3/8-in. nuts. Tighten to specifications.

Specification

End Cap Nuts -Torque 27.5 N·m (20 lb-ft)

5. Repeat on opposite side.

6. Adjust gauge wheels. (See ADJUST GAUGE WHEELS in the Final Inspection and Adjustments section.)

NOTE: (To complete predelivery setup, go to General Assembly section.)

E48487

Left-Hand Side Shown


A-Gauge Wheel Arm Assembly
B-Straps
C-Cap Screws, M12 x 16
D-End Cover

AG,OUO6059,284 -19-26JUN03-2/2