Setting Number of Twine End Wraps

Set Number of Right-Hand and Left-Hand End Wraps:

NOTE: The bale will have twice the number of left-hand end wraps, as indicated on the monitor-controller, when the twine contacts the twine guide. (See SETTING TWINE END WRAP DISTANCE in this section.) The setting for the number of end wraps is approximate for each twine arm.

1. Turn tractor key to ON position. Do not start tractor engine. Turn monitor-controller ON.

2. Press left-hand END WRAP key (B) or right-hand END WRAP key (C). Press PLUS or MINUS keys until desired number of end wraps (.5-5) appears in digital display. After six seconds, setting will be entered into memory.

3. Turn monitor-controller to OFF. Turn tractor key to OFF position. Remove key.

E52445


A-Twine Symbol
B-Left-Hand End Wrap Key
C-Right-Hand End Wrap Key

OUMX005,000004B -19-28SEP00-1/1