Adjusting Lower Feed Roll Scraper

causym CAUTION: To avoid injury or death caused by unexpected lowering of the gate, engage gate lock before working on, around, or under gate in raised position.

1. Open gate fully, then lower to a convenient height.

2. Shut off tractor engine and remove key.

3. Lock the gate.

4. Verify that tension arm is fully raised and against its stops.

TS698

OUMX005,0000077 -19-02OCT00-1/2

5. Loosen mounting lock nuts on scraper (A).

6. Using feeler gauge, adjust scraper (A) until roll-to-scraper clearance is within specifications at tightest points. Tighten lock nuts.

Specification

Lower Front Gate Roll-to-Scraper -Clearance 2.5-5.5 mm (3/32-7/32 in.)

7. Rotate roll to make sure scraper does not hit roll at any point as roll is rotated.

8. Unlock gate and lower completely.


A-Scraper
B-Gate Roll

E21748

Non-Net Wrap Balers

E40236

457S and Net Wrap Balers

OUMX005,0000077 -19-02OCT00-2/2