Checking and Adjusting Lower Net Wrap Guide

1. Check that belts are not pinched between lower belt guide straps (A) and crossbar (B). Belts must be positioned between the guide straps.

NOTE: Use 5/32 in. drill bit as a gauge to check clearance between guide straps and crossbar.

2. Check clearance between ends of all belt guide straps and bottom crossbar. Clearance must meet specifications.

Specification

Ends of Belt Guides-to-Bottom Crossbar -Clearance 3-5 mm (0.118-0.197 in.)

E40608


A-Belt Guide Strap
B-Crossbar

OUO6059,0000007 -19-05SEP00-1/5

3. Remove lock nuts (A) and insert washers as necessary.

4. Install and tighten lock nuts.

5. Check belt guide washer-to-lower net wrap guide clearance (B) on both sides of machine. Clearance should be within specifications.

Specification

Belt Guide Washer-to-Lower Net Wrap Guide -Clearance 1-4 mm (0.039-0.157 in.)

E48750


A-Lock Nut
B-Clearance

OUO6059,0000007 -19-05SEP00-2/5

IMPORTANT: When pan adjustment is complete, the pan should be contacting at least two belts. If pan is not touching belts, adjust crosstube to a higher position moving pan closer to the belts. Adjust both ends of crosstube as needed.

6. If lower rear gate roll is adjusted at the bottom of slot (A), adjust right-hand side crosstube to lowest position (B), as shown.


A-Roll Low Position
B-Guide Low Position

E48100

OUO6059,0000007 -19-05SEP00-3/5

7. If lower rear gate roll is adjusted at the top of slot (A), adjust right-hand side crosstube to highest position (B), as shown.


A-Roll High Position
B-Guide High Position

E48098

OUO6059,0000007 -19-05SEP00-4/5

8. If lower rear gate roll is adjusted to a position (A) between top and bottom of the slot, adjust right-hand cross tube to corresponding position (B) between top and bottom of slot.

9. Check belt tracking. (See CHECKING BELT TRACKING in Service-Baler section.)


A-Roll Middle Position
B-Guide Middle Position

E48099

OUO6059,0000007 -19-05SEP00-5/5