Installing BALE WATCH™ Monitor on 7000/7010 Series Open-Station Tractor
E40153
E40155


A-Bracket
B-U-Bolts
C-Monitor
D-Monitor Strap (Optional)
E-Wiring Harness
F-Tie Bands

Monitor Bracket on Cowling

1. Install bracket (A) over tractor hood. Fasten with two U-bolts (B), four washers, and four nuts.

2. Install monitor (C) on bracket in convenient location. Fasten with knob and round-head bolt.

  • If equipped with optional strap (Order strap from Service Parts):

    a. Install monitor strap (D) to bracket (A). Fasten with cap screw, washer, and flange nut.
    b. Install monitor on monitor strap. Fasten with knob and round-head cap screw.

3. Route wiring harness (E) as follows:

  • Tractor WITHOUT Optional Right-Hand Step;

    a. Route wiring harness along bracket, railing, and around control console.
    b. Plug BALE WATCH ™ harness power plug into tractor convenience outlet.
    c. Route baler plug to rear of tractor.

    E40154

    Optional Monitor Strap Illustrated

BALE WATCH is a trademark of Deere & Company

OUO6059,000004D -19-05SEP00-1/4

    d.
  • Fasten wiring harness to railing and bracket with tie bands (F) (tie bands not provided).

OUO6059,000004D -19-05SEP00-2/4

  • Tractor WITH Optional Right-Hand Step;

    a. Route wiring harness down hood and under platform.
    b. Fasten harness to U-bolt with tie band.
    c. Fasten harness under platform with tie bands (A) (tie bands not provided).
    d. Route harness around control console. Plug BALE WATCH ™ harness power plug into tractor convenience outlet or, if equipped, to electric twine controller harness.
    e. Route baler plug to rear of tractor.


A-Tie Bands

    E40157

BALE WATCH is a trademark of Deere & Company

OUO6059,000004D -19-05SEP00-3/4

    Monitor Bracket on Hand Rail

        1.

        Install bracket (A) on railing (B). Fasten with two U-bolts (C), four washers, and four nuts.

        2.

        Install monitor (D) on bracket. Fasten with knob and round-head cap screw.

        3.

        Route wiring harness (E) around bracket and control console.

        4.

        Plug BALE WATCH ™ harness power plug into tractor convenience outlet.

        5.

        Route baler plug to rear of tractor.


        A-Bracket
        B-Railing
        C-U-Bolts
        D-Monitor
        E-Wiring Harness

    E40158

BALE WATCH is a trademark of Deere & Company

OUO6059,000004D -19-05SEP00-4/4