Installing BALE WATCH™Monitor in COMFORTGARD™ Cab

NOTE: On some newer tractors, its necessary to remove the foam corner post panel to gain access to the mounting studs. Also, panel will need to be drilled in order to fasten the bracket (see photo).

1. Remove the top two plugs from the lower right-hand front cab post.

2. Install angle (A) to cab post. Fasten with two flange-head cap screws.

3. Install monitor strap (B) to angle (A). Fasten with cap screw (C), washer (D) and flange nut (E).

4. Place monitor pivot bracket (factory installed) on top of mounting bracket and attach using M6 x 16 cap screw.

5. Route harness along right-hand side of cab, away from operation levers, to rear of side console.

A-Angle
B-Monitor Strap
C-Cap Screw
D-Washer
E-Flange Nut

BALE WATCH is a trademark of Deere & Company
COMFORTGARD is a trademark of Deere & Company

OUO6059,0000051 -19-05SEP00-1/2

7. Route baler plug through back wall of cab at a convenient location or drill a 44 mm (1-3/4 in.) diameter hole in rear wall, if required.

A-Tractor Convenience Outlet

OUO6059,0000051 -19-05SEP00-2/2