Adjusting Compressor Rod Channel (MEGATOOTH and MegaWide Pickup)

Compressor rod channel reduces compressor rod breakage and helps keep rods from being caught and held by starter roll.

Adjust channel whenever compressor rods are replaced or if channel has been removed.

1. Loosen nuts (A) on compressor rod channel (B).

2. Adjust channel (B) until dimension (C) is within specifications between compressor tube (D) and channel (B).

Specification

Compressor Tube-to-Channel -Distance 50 mm (2 in.)

NOTE: Do not overtighten nuts. Overtightening can cause channel to collapse and not retain compressor rods.

3. Tighten nuts (A).

E40719


A-Nuts
B-Compressor Rod Channel
C-Dimension
D-Compressor Tube

OUO6059,0000061 -19-06SEP00-1/1