|
False slip indication
|
Slip alarm sounds without either clutch slipping
|
Check pickup sensor by viewing RPM, (See Verify Operation and Adjustment of Sensors in Service section)
|
|
|
|
Check PTO Speed on channel 204 is properly set, (See Turning Optional Features On and Off in Service Section)
|
|
|
|
Slip alert feature can be temporarily turned off (See above)
|
|
One of the clutches slip but the slip alarm does not sound
|
Monitor not recieving PTO sensor input
|
Check PTO sensor by viewing RPM (See Service section)
|
|
|
Both sensors have not been activated
|
Check that both sensors are activated and PTO set at proper speed (See service section)
|
|
Twine or net wrapping does not correct for slower speed
|
Improper sensor adjustment, faulty sensor, broken wires
|
Check PTO sensor by viewing RPM (See Service section)
|
|
|
|
Check PTO speed on channel 204 is properly set (See above)
|
|
Pickup sensor is damaged
|
Tone wheel on clutch has moved into sensor
|
Remove end play be adding washers between starter roll and roll pin and clutch and roll pin
|