BaleTrak™ Pro Monitor-Controller Setup Values and Initial Settings
| BALE DIAMETER |
| Readout Display Range |
22.5-75 in. (57-191 cm) |
| Diameter Adjustment Range |
32-72 in. (81-183 cm) |
| Diameter Initial Settinga |
66 in. (168 cm) |
| Near Full Size Range |
0.5-10.0 in. (1-27 cm) |
| Near Full Size Initial Settinga |
4.5 in. (11 cm) |
| Bale Shape Sensitivity Range |
1 (slowest)-5 (fastest) |
| Bale Shape Sensitivity Initial Settinga |
3 (medium) |
| Spacing Range |
1-10 in. (2-26 cm) |
| Spacing Initial Settinga |
4 in. (10 cm) |
| Number of End Wraps Range |
| Left-Hand End |
0-5 Wraps |
| Right-hand End |
0.5-5.0 Wraps |
| Number of End Wraps Initial Settinga |
2 Wraps |
| Left-Hand, Right-Hand End Wrap Distance Range |
3-10 in. (8-26 cm) |
| End Wrap Distance Initial Setting (Right and Left-Hand)a |
4 in. (10 cm) |
| Re-Extension Wrap Distance Range |
OFFa,8, 16, 24 in. (20, 40, 60 cm) |
| Cinch Wrap Initial Setting (From Left-Hand End) |
OFFa,10 in. (25 cm) |
| Dry Straw |
OFFa, ON |
| Number of Wraps |
1.5-5.0 |
| Number of Wraps Initial Settinga |
2 |
| Time Delay Range (From Full-Size Bale Alert to Start of Net Wrap Cycle) |
0-8 Seconds |
| Time Delay Initial Settinga |
2 Seconds |
| Diameter Adjustment Range |
24-68 in. (61-173 cm)b |
| Diameter Initial Settinga |
36 in. (91 cm) |
| aSettings revert to these values when monitor-controller is reset. (See BaleTrak™ Pro MONITOR-CONTROLLER-RESET TO INITIAL SETTINGS [CH 001] in this section.) |
| b4 in. (10 cm) below size setting. |
|
BaleTrak is a registered trademark of Deere & Company
|
AG,OUO6059,216 -19-09APR03-1/1
|
|