Adjusting Lower Feed Roll Scraper

causym CAUTION: To avoid injury or death caused by unexpected lowering of the gate, engage gate lock before working on, around, or under gate in raised position.

1. Open gate fully.

2. Shut off tractor engine and remove key.

3. Lock the gate.

4. Loosen mounting lock nuts on scraper (A).

5. Using feeler gauge, adjust scraper (A) until roll-to-scraper clearance is within specifications at tightest points. Tighten lock nuts.

Specification

Lower Front Gate Roll-to-Scraper -Clearance 2.5-5.5 mm (3/32-7/32 in.)

6. Rotate roll to make sure scraper does not hit roll at any point as roll is rotated.

7. Unlock gate and lower completely.

TS698
E21748


A-Scraper
B-Gate Roll

OUO6077,0001966 -19-12JUN06-1/1