Adjusting Intermittent Drive Gear-Wire Baler

To eliminate tooth breakage and ensure proper mesh, the flat side of the gripper drive pinion must be flush to maximum clearance (A) as specified from the smooth surface of the intermittent drive gear.

Specification

Pinion-to-Drive Gear -Maximum Clearance (A) 0.25 mm (0.010 in.)

1. Remove pin (B) and loosen bolt (C) in needle lift shaft and position washers (D) to get proper mesh.

2. Replace pin in shaft and tighten bolt.

E18029


A-Clearance
B-Pin
C-Bolt
D-Washers

OUO6038,000009C -19-28SEP00-1/1