|
Material not distributed evenly in bale.
|
Feeder fingers out of adjustment.
|
Adjust feeder fingers. (See ADJUSTING FEEDER FINGERS in Operating the Baler section.)
|
|
Banana shaped bale.
|
Ground speed of baler too slow and/or windrow too small.
|
Increase ground speed, reduce baler rpm speed and/or make larger windrows. (See STARTING AND OPERATING THE BALER in Operating the Baler section.)
|
|
|
|
Decrease baler speed. (See STARTING AND OPERATING THE BALER in Operating the Baler section.)
|
|
|
Bale tension too loose.
|
Increase bale tension. (See ADJUSTING TWINE TENSION in Operating the Baler section.)
|
|
|
Bailing extremely light hay.
|
Incorrect feeding. (See STARTING AND OPERATING THE BALER in Operating the Baler section.)
|
|
Ragged bale.
|
Dull knives. Plungerhead out of adjustment.
|
Sharpen knives. Adjust plungerhead. (See ADJUSTING PLUNGERHEAD in Service section.)
|
|
Irregular bale length.
|
Measuring arm bounces.
|
Add or remove shims accordingly. (See ADJUSTING BALE MEASURING CONTROL in Service section.)
|
|
|
Low bale density.
|
Increase ground speed, windrow size, and/or bale tension. (See STARTING AND OPERATING THE BALER and ADJUSTING TWINE TENSION in Operating the Baler section.)
|