|
Pickup teeth digging in ground.
|
Pickup set too low.
|
Raise pickup. (See ADJUSTING PICKUP FLOTATION in Service section.)
|
|
Not picking up hay clean.
|
Pickup stays up.
|
Loosen lift spring. Check pivots. (See ADJUSTING PICKUP FLOTATION in Service section.)
|
|
|
Pickup teeth set too high.
|
Lower pickup. (See ADJUSTING HEIGHT OF PICKUP TEETH in Operating the Baler section.)
|
|
|
Ground speed too fast.
|
Reduce ground speed.
|
|
|
Hay not all raked.
|
Turn all hay onto clean stubble.
|
|
|
Pickup teeth bent or broken.
|
Straighten or replace teeth.
|
|
|
Windrows too light.
|
Rake heavier windrows.
|
|
Pickup teeth do not revolve.
|
Belt slipping.
|
Replace or tighten belt and raise compressor. (See ADJUSTING AUGER DRIVE BELT in Service section.)
|
|
Pickup tooth breakage.
|
Set too low.
|
Raise pickup. (See ADJUSTING PICKUP FLOTATION in Service section.)
|
|
|
Foreign material inside and/or broken teeth.
|
Remove foreign material and/or teeth.
|