|
Main drive slip clutch slips excessively during normal operation.
|
Slip clutch cap screw loose.
|
Adjust clutch cap screw. (See ADJUSTING SLIP CLUTCH in Service section.)
|
|
|
Shear cap screw sheared in flywheel.
|
Replace shear bolt. (See REPLACING FLYWHEEL SHEAR BOLT in Operating the Baler section.)
|
|
|
Clutch facings glazed. Oil or grease on facings.
|
Clean or replace facings.
|
|
|
Exceeding baler capacity.
|
Make 12 to 18 charges into a 36 in. bale. (See STARTING AND OPERATING THE BALER in Operating the Baler section.)
|
|
Powershaft will not telescope correctly.
|
Tractor drawbar not installed correctly.
|
Install drawbar correctly.
|
|
|
Powershaft bent or twisted.
|
Replace.
|
|
Powershaft vibrates excessively.
|
Powershaft bent or twisted.
|
Replace.
|
|
|
Tractor operating at an excessive angle.
|
Check hookup dimensions. (See Preparing the Tractor section.)
|
|
|
Powershaft cross bearings worn.
|
Replace bearings.
|
|
Powershaft will not stay engaged.
|
Splines on tractor yoke worn.
|
Replace yoke.
|