|
1.
Remove grease from knotter mechanism.
2.
Remove heavy oil and grease from bale case and chains and lubricate with 30W or heavier oil.
3.
Lubricate complete baler. (See Lubrication and Maintenance section.) This will force any collected moisture out of bearings.
4.
Check tires for correct air pressure.
5.
Check and fill gear case to check plug level.
6.
Tighten all hardware.
|
7.
Adjust and check timing of entire baler. (See Service section.)
8.
If any major moving parts have been replaced, they should be run in.
9.
Check slip clutch to be sure linings are not bonded to metal plates. Readjust slip clutch. (See ADJUSTING SLIP CLUTCH in Service section.)
10.
Review Operator's manual and check adjustments.
|