BALETRAK PLUS® Monitor-Controller Diagnostic and Setup Channels

NOTE: Channel listings and page numbers can be found under Operating the Baler or Service-

Baler in the Contents or under section "C" in the Index.

CHANNEL NUMBER SECTION FUNCTION
1 Operating Return to Initial Settings
3 Service-Baler Adjust Twine Wrap Sensor with Sound
5 Service-Baler Adjust Bale Diameter Sensor with Sound
7 Service-Baler Adjust Right Bale Shape Bar Display and Sensor with Sound
9 Service-Baler Adjust Left Bale Shape Bar Display and Sensor with Sound
10 Service-Net Wrap Testing Net Wrap Switch
11 Service-Baler Testing Oversize Bale Switch
12 Service-Baler Testing Right-Hand Gate Latch Switch
13 Service-Baler Testing Left-Hand Gate Latch Switch
14 Service-Baler and Service-Net Wrap Testing Twine or Net Actuator Current
15 Service-Baler Checking Tractor Voltage
16 Service-Baler Testing Liquid Crystal Display
17 Operating Dry Straw Twine Wrap Program
18 NOT USED  
19 NOT USED  
20 NOT USED  
21 NOT USED  
22 NOT USED  
23 NOT USED  
24 Operating Adjust Bale Shape Sensitivity
25 Operating Adjust Near-Full Indicator
26 Operating Net Wrap Delay
27 NOT USED  
The following channels have been programmed to perform adjustments WITHOUT the audible alarm.
CHANNEL NUMBER SECTION FUNCTION
2 Service-Baler Adjust Twine Wrap Sensor
4 Service-Baler Adjust Bale Diameter Sensor
6 Service-Baler Adjust Right Bale Shape Bar Display and Sensor
8 Service-Baler Adjust Left Bale Shape Bar Display and Sensor

 

BALETRAK PLUS is a registered trademark of Deere & Company

AG,OUO6017,1621 -19-03NOV99-1/1