Straighten Cutoff Indicator Channel

1. Turn tractor key to ON position. Do not start tractor engine. Press and hold DEERE key (A). Set selector switch to NET symbol to turn monitor-controller ON. "CH 01" will appear in the digital display.

2. Continue to hold DEERE key and press PLUS key to advance to "CH 14". Release DEERE key.

3. Press and hold RETRACT key (C) to move knife to rear position.

4. Set monitor-controller selector switch to OFF (centered) position. Turn tractor key to OFF position. Remove key. Disconnect monitor-controller power plug from tractor convenience outlet.

5. Open net wrap cover.

E47604


A-DEERE Key
B-EXTEND Key
C-RETRACT Key

AG,OUO6040,470 -19-22OCT99-1/2

causym CAUTION: Be careful when working around the knife. It is sharp. Wear gloves when handling knife.

6. To straighten channel, insert screwdriver between channel (A) and net guide (B). Straighten channel.

7. Adjust net wrap switch. (See CHECKING AND ADJUSTING NET WRAP SWITCH in this section.)

IMPORTANT: Make sure to move net wrap knife fully forward to "home" position. If baler is operated with knife at the rear position, net will feed continuously during baling.

8. Connect monitor-controller power plug to tractor convenience outlet. Turn tractor key to ON position. Do not start tractor engine. Press and hold DEERE key while turning monitor-controller selector switch to NET. "CH 01" will appear in the digital display.

9. Continue to hold DEERE key and press PLUS key to advance to "CH 14". Release DEERE key.

10. Momentarily press WRAP key to cycle net wrap actuator to return knife to home (forward) position.

11. Set monitor-controller selector switch to OFF (centered) position. Turn tractor key to OFF position.

12. Close net wrap cover.

TS268
E41732


A-Channel
B-Net Guide

AG,OUO6040,470 -19-22OCT99-2/2