Hydrostatic Drive Control Lever

IMPORTANT: If the hydrostatic charge pressure light comes on in the warning display panel when the lever is moved, check hydrostatic/hydraulic oil level or replace filter. If this doesn't correct the problem, see your John Deere dealer.

Move lever forward to go forward.

Move lever to the right and rearward to go backward.

AG,OUO6038,1040 -19-08OCT99-1/2

To adjust handle angle, turn handle (A) counterclockwise to loosen collar (B). Position handle, tighten collar with fingers, then turn handle clockwise to tighten collar firmly.

If additional tightening of the handle is required, position hydrostatic handle approximately 20 degrees counterclockwise from the desired position. Tighten collar with fingers. Hold collar with fingers and turn handle clockwise to desired position.

Do not use pliers on collar, tighten with fingers.

A-Handle
B-Collar

AG,OUO6038,1040 -19-08OCT99-2/2