A-Hydrostatic Control Lever
B-Neutral Start Switch
C-Engine Air Filter
D-Hydrostatic Charge Pressure

E-Hydrostatic Oil Filter
F-Operator Presence
G-Low Fuel
H-Engine Oil Pressure

I-Engine Coolant Temperature
J-Hydrostatic Oil Temperature

K-Alternator
L-Float Pressure Low
M-Park Brake Applied
N-Road Shift Engaged

IMPORTANT: Failure to replace a failed light bulb could lead to serious machine failure. Replace any failed light bulbs before starting the engine.

NOTE: The warning light check is only checking the operation of the light bulbs in the warning display panel.

Road Shift Engaged (N) will only light if the Field/Road switch is in the road position.

Park Brake Applied (M) will only light when the neutral start switch (B) is activated.

The Road Shift Engaged and Park Brake Applied lights (blue) are informational only, not indicating a hazard when on.

1. With hydrostatic control lever (A) in neutral position, move lever to the right to release neutral start switch (B).

2. Turn ignition switch to the START position.

3. Warning lights (C-L) should light. Return ignition switch to OFF position and allow hydrostatic control lever to move into position.

AG,OUO6038,1083 -19-08OCT99-1/1