Power Source

A power source connector (A) is available for providing power to additional components or appliances as needed.

The connector is located in the compartment on the right-hand side of the cab.

In order to use the connector it will be necessary to install a three terminal METRI-PACK ™ connector on the lead wires from the component.

The power source system has two circuits, each protected by a 10 amp fuse and is accessible through the hole in the lower panel to the right of the operator's seat.

• Wire 38 has current to it only when the ignition switch is on.
• Wire 39 has current to it all the time.
• Wire 10A goes to ground.

A-Connector

METRI-PACK is a trademark of Delphi Packard Electric Systems.

AG,OUO6038,1164 -19-11OCT99-1/1