Cab Headlight Bulb Replacement and Adjustment

causym CAUTION: Raise platform fully and engage safety stop before standing on platform to replace or adjust cab headlights.

1. Remove three screws (A) to remove headlight (B).

2. Disconnect wiring connector (C). Clean dirt from headlight.

3. Push in and twist retainer ring (D) counterclockwise. Bulb pulls straight out.

causym CAUTION: Before replacing the headlight bulbs, read Halogen Bulb Safety Guidelines in this group.

IMPORTANT: Do not over tighten the screws. Tightening screws until they bottom out can break the headlight.

4. When installing headlight, adjust as follows:

a. Start with the two end screws first, then the bottom screw last.

b. Adjust the screws until all three tabs are flush with the panel.

H39475


A-Screw (3 used)
B-Headlight
C-Wiring Connector
D-Retainer Ring

AG,OUO6038,1171 -19-11OCT99-1/1